Guide · 6 min read
How to Measure Your Blood Pressure at Home
Get readings you can trust: the right cuff, the 5-minute rest, and the 7-day protocol doctors use — plus the mistakes that quietly add 5–20 mmHg to…
Last updated: 2026-11-13
Tools for this guide
The short answer
Rest five minutes, sit with your back supported and feet flat, put the cuff on bare skin at heart level, and take two readings one minute apart. Do that morning and evening for seven days, drop day 1, and average the other 24 readings — that average is the number that matters.
A home average of 130/80 mmHg or higher is high under the 2025 AHA/ACC guideline. Everything in this guide follows that protocol: the same steps your clinician's office uses, written for your kitchen table.
Pick a validated upper-arm monitor
Buy an upper-arm monitor that has been independently validated — validatebp.org lists the models that passed testing. Wrist and finger monitors are not recommended: a wrist held a few centimetres too high or low changes the reading, and finger devices are worse.
Avoid monitors that only advertise 'clinically tested' without a validation listing — that phrase is marketing, not a test result. A validated upper-arm monitor costs about the same as an unvalidated one, so there is no reason to gamble.
Measure your arm and fit the cuff
Wrap a tape measure around the middle of your upper arm and buy the cuff size that covers that measurement. A cuff one size too small adds about 5 mmHg to your systolic reading; two sizes too small adds about 20 mmHg — enough to turn a normal reading into a high one.
Put the cuff on bare skin, never over a sleeve: even a thin shirt under the cuff can add a few mmHg. The bottom edge sits just above the bend of your elbow, with the tube running down the inside of your arm.
The 30 minutes before you measure
No caffeine, no smoking, and no exercise for 30 minutes before a reading, and empty your bladder first — a full bladder raises blood pressure. Sit and rest for five minutes before you press start: walking in from outside and measuring immediately is the commonest way to get a falsely high number.
Sit in a chair with your back supported, feet flat on the floor, legs uncrossed, and your arm resting on a table at heart level. Do not talk, do not look at your phone, and do not cross your legs — each of those quietly pushes the number up.
The 7-day protocol, step by step
Take two readings one minute apart, morning and evening, for seven days. That is 2 × 2 × 7 = 28 readings. Discard all four of day 1's readings — the first day always runs high while you get used to the routine — and average the remaining 24.
Worked example: six days of morning/evening averages of 131/83, 133/85, 130/82, 134/86, 132/84 and 132/84 add up to 792 systolic and 504 diastolic over 6 days — an average of 132/84 mmHg. That is above the 130/80 home threshold, so it is worth a conversation with a clinician, not a panic and not a diagnosis.
Mistakes that change your numbers
The big ones: a cuff that is too small (+5 mmHg for one size, +20 mmHg for two), measuring right after coffee, exercise or a cigarette, a full bladder, talking during the reading, legs crossed, arm hanging below heart level, and a cuff over a sleeve. Each one alone can move the reading by several mmHg; stacked together they can fake hypertension.
The fix is boring and it works: same time of day, same chair, same arm, same rest, same silence. Write every reading down or use the log in the Blood Pressure Checker — a written record beats memory, and it is what your clinician actually wants to see.
What the numbers mean — and what to do next
Check your 24-reading average against the 2025 AHA/ACC categories: below 120/80 is normal, 120–129 with diastolic under 80 is elevated, 130–139 or 80–89 is stage 1, 140/90 or higher is stage 2. The Blood Pressure Checker classifies any reading for you, including the home average.
If your home average is 130/80 or higher, book a clinician appointment and bring the log — do not start, stop or change any medication on the basis of home readings. This guide is general information, not medical advice, and a home average is a reason to talk to a professional, never a diagnosis by itself.
Frequently asked questions
How often should I measure my blood pressure at home?
For a useful average, follow the 7-day protocol: two readings one minute apart, morning and evening, for seven days. That gives 28 readings; drop day 1 and average the remaining 24. A single reading — or a single day — is not enough to judge anything.
What counts as high blood pressure at home?
A home average of 130/80 mmHg or higher is high, under the 2025 AHA/ACC guideline. That threshold is lower than the 140/90 used in some clinics because home readings run a little lower than office readings. One high reading is not a diagnosis — it is the average that matters.
Does cuff size really change the reading?
Yes, and by more than most people expect. A cuff one size too small adds about 5 mmHg to the systolic number; two sizes too small adds about 20 mmHg. Measure your arm and buy the cuff size that fits — a 'one size fits all' cuff fits almost nobody well.
Why is my first reading always the highest?
Your body reacts to the act of measuring — sitting down, the cuff inflating, watching the numbers. That is why the protocol takes two readings one minute apart and why day 1 is discarded: the first readings of a session and of a week both run high, then settle.
Can I use a wrist monitor instead?
Upper-arm monitors are the ones validated for accuracy; wrist and finger monitors are not recommended for home measurement because small changes in wrist position change the reading. If an upper-arm cuff genuinely does not fit, ask your clinician which device to use instead of guessing.
Try it now — free, no signup
Your numbers, classified the AHA way. Nothing you type is sent to a server.
Open Blood Pressure Checker
