FOOD
How to Cook Rice Perfectly Every Time
How to cook rice perfectly: the right water ratio for white, basmati, jasmine and brown rice, why the ratios disagree, and the 10-minute rest.
Last updated: 2026-11-15 · 6 min read
Why rice goes wrong
Rice is the most cooked food on Earth, and also one of the most often ruined. It comes out gluey, or crunchy in the middle, or burnt on the bottom, and the advice does not help, because one recipe says one and a half cups of water per cup of rice and the next says two cups, for the same rice.
Both can be right, and that is the first thing to understand. A rice ratio is not a law of nature. It depends on the type of rice, the pot, the lid, the heat, and how much steam escapes. The method below removes most of that guesswork, and the section after it explains why the numbers disagree, so you can adjust with confidence instead of following a recipe blindly.
Good rice needs four things: rinsed grains, the right amount of water for the type, low steady heat, and a covered rest at the end. Get those four right and the rice is fluffy and separate almost every time. Skip any one of them and the pot will tell you.
The one method that works for white rice
Start with 1 cup of long-grain white rice. Rinse it in cold water three or four times, swirling with your fingers, until the water runs mostly clear. This washes off loose surface starch, which is what makes rice gummy and clumped. Drain it well.
Put the rice in a heavy pot with a tight-fitting lid. Add 1 1/2 cups of water and a pinch of salt. Bring it to a boil, then put the lid on, turn the heat to the lowest setting, and cook for 15 minutes. Do not lift the lid. Every time the lid comes off, steam escapes, and steam is doing the cooking.
When the time is up, take the pot off the heat and leave it alone, lid still on, for 10 minutes. This rest is part of the cooking: the trapped steam finishes the centres of the grains and lets the moisture spread evenly. Then fluff gently with a fork, and serve. The whole method is one cup of rice, one and a half cups of water, 15 minutes on low heat, 10 minutes resting.
One method per type
Different rice needs different water and time, because the grains absorb water differently. Basmati is the closest to white rice: rinse it very well, use 1 1/2 cups of water per cup of rice, and simmer for 12 to 15 minutes, then rest for 10 minutes. Soaking basmati for 20 to 30 minutes first is optional, but it helps the long grains cook evenly and stay separate.
Jasmine rice is softer and slightly stickier, so it needs a little less water: 1 1/4 cups of water per cup of rice, simmered for about 12 minutes, then rested for 10 minutes. Short-grain rice, the kind used for sushi, is similar: 1 1/4 cups of water, about 15 minutes of simmering, and a 10-minute rest.
Brown rice is a different job, because the grain still has its outer bran layer. It needs 2 cups of water per cup of rice and about 40 minutes of simmering, then the same 10-minute rest. If your brown rice is still firm after 40 minutes, it is usually undercooked rather than under-watered: put the lid back on and give it another 5 to 10 minutes on low heat.
Why the ratios disagree
The honest reason recipes quote 1:1.5 and 1:2 for the same rice is that the ratio measures the pot as much as the rice. A wide pot loses more steam than a tall narrow one. A loose lid loses more than a tight one. A strong simmer boils water away faster than a gentle one. And rice cooked in a rice cooker needs far less water, about 1.1 cups per cup of rice, because almost no steam escapes.
Measuring matters too. A cup of rice scooped straight from the bag packs more grains than a cup spooned in lightly, and the same is true of the water if your cup is not level. Use the same cup for the rice and the water, level it off, and your ratio will be consistent even if it is not the number on a chart.
Altitude plays a part as well. High above sea level, water boils at a lower temperature, so rice needs more time and a little more water. And older, drier rice absorbs more water than a fresh bag. None of this means the ratios are wrong. It means they are starting points, and the right one for your kitchen is the one that works in your pot, on your stove, with your rice.
Fixing common problems
Mushy rice usually means too much water, or the lid was lifted and the heat was turned up to compensate, which only makes it worse. Next time, use a little less water and keep the heat low. Rice that is already mushy can sometimes be saved by spreading it on a tray to cool, which dries the surface.
Crunchy rice in the middle usually means it needed more time, not more water. If the pot is dry, sprinkle 2 to 4 tablespoons of hot water over the rice, put the lid back on, and cook on the lowest heat for another 5 to 10 minutes. If the pot still has water but the rice is crunchy, the heat was too high and the water boiled away before the grains were done.
Rice stuck and burnt on the bottom means the heat was too high or the pot was too thin. A heavy pot and the lowest heat setting prevent most of it. And if the rice smells slightly scorched, do not stir it: serve the top layers and leave the burnt layer in the pot.
For food safety, treat cooked rice like any cooked food. Do not leave it at room temperature for more than 2 hours. Cool it quickly, spread it out if there is a lot of it, and refrigerate it promptly in a shallow container.
Related on Gargloo
Frequently asked questions
Should I rinse rice before cooking?
Yes, for most white, basmati, jasmine and short-grain rice. Rinse three or four times in cold water until it runs mostly clear. It removes loose surface starch that makes rice gummy. Skip rinsing only if a recipe needs the starch, such as risotto or rice pudding.
Do I need to soak basmati rice?
No, it is optional. Soaking basmati for 20 to 30 minutes helps the long grains cook evenly and stay separate, but the rice still cooks well without it. If you soak it, drain it well and keep the same 1 1/2 cups of water per cup of rice.
Can I lift the lid while rice is cooking?
No. Steam is doing the cooking, and lifting the lid lets it escape, which is the most common reason rice ends up crunchy or uneven. Leave the lid on through the simmer and the 10-minute rest.
How much water do I need for brown rice?
About 2 cups of water per cup of brown rice, simmered for about 40 minutes, then rested covered for 10 minutes. Brown rice keeps its bran layer, so it needs more water and roughly three times as long as white rice.

